Dynamic Handset 96"

The Dynamic V1 Handset features a high-quality receiver and a Dynamic microphone. The handset is constructed of durable ABS plastic combined with a high-strength stainless cord and steel lanyard.  The Dynamic V1 handset includes a low-impedance dynamic microphone. For applications that require a microphone with higher impedance, please see the Dynamic V2 handset. See the technical specifications of each Dynamic handset for more info.

Each handset consists of the following elements:
- Handset type: SD-45150H20 Standard Receiver and DT-05 Dynamic Type 1 Transmitter.
- Handset handle and cap material: ABS plastic
- Wiring: Four 24-gauge Teflon-insulated wires (2 for receiver, 2 for transmitter) with a single modular plug (Optional 4-spade conductors)

Armored Cord Assembly.:
- 304 Stainless Steel, Interlock style. Inside Diameter, 0.250", 6.350mm. Outside Diameter, 0.329", 8.357mm. Linear Pull Test Load, 1000 lbs., 454 kg

- Includes a steel lanyard, which is anchored to the handset handle. The steel lanyard has a pull test load of approximately. 1000 lbs, 454 kgs.
- Other Components: lanyard block retainer; anti-rotation wedge; transmitter holder; blue rubber grommet to seal handset/cord connection

SD-45150H20 Standard Receiver:
- DC Resistance at 20 degrees C: 145 ± 15 ohms- Frequency Response Range: 300-3400 Hz
- Sensitivity: 100 ± 2 dB at 60mv
- Impedance: 150 ± 30 ohms at 1 KHz

DT-05 Dynamic Type 1 Transmitter:
- Type: Dynamic Type Transmitter
- Response Range: -66 ± 3.5dBV(300-3300Hz)
- Frequency Response : 1KHz: -66 ± 3.5 dbV
- Impedance: 150 ± 30 ohms- Electrostatic Discharge: Breakdown Volt. 15KV.Min
- Screw terminal

Handset caps are sealed with high-strength epoxy adhesive prior to shipping, unless otherwise requested.

Master Case Qty: 15 pcs

 4-pin modular connectors are supplied with most handsets at no additional cost, while supplies last.  Certain handset variants that require modular connectors may require an upcharge.